How Long Will The Bleeding Last?
When the quick has been cut the nail will normally bleed for a few minutes but it ultimately depends on how much of the quick has been cut.
Sometimes a dog’s quick will bleed a lot and leave a pool of blood which can be scary but that’s what any blood vessel does when it’s cut.
If the bleeding doesn’t stop after 20-30 minutes you should contact your veterinarian.
Depending on the severity of the nail injury, most dogs are fine after a few minutes but some quick injuries might take up to 24 hours.
A dog’s quick rarely gets infected from trimming it too short but it is possible.
The quick is attached to a bone in the dog’s paw and if the nail is injured it can lead to a bone infection which can be trouble.
These types of infections usually happen due to a broken nail that has been broken to the base and hasn’t been treated.
Signs that the quick is infected can be:
Infected nails need to be treated by a veterinarian and can not be treated at home.
Keep an eye on those toe beans!
Why Do You Need to Cut Your Dogs Nails?
For starters, when you allow nails to grow too long or to become overgrown, this also means that the quick has grown out, which can lead to nail bed issues, bleeding nails, pain, secondary issues in your dogs body, and a worried pet owner.
What Is a Nail Quick?
The quick of a nail is the innervated, vascularized core of the nail bed. It provides nourishment to the nail which allows it to grow and aids sensation.
The quick of the dog nail is vascularized and innervated.
Trimming Your Dog’s Nails
If your dogs nails are very long and the quick is very close to the tip of the nail, you may have no other choice than to only trim the very tip of the nail to prevent bleeding and pain. You will likely use these types of common nail clippers:
How To SUCCESSFULLY Recede The Quicks (Watch If You Have Struggled!)
Nail cutting is essential because nails that are too long and resting on the ground can affect the dog’s posture and their movement it can get uncomfortable or sore for the dog, they can cause deformed feet and injure the tendons over an extended period. As the long nail hits the ground, the pressure puts force on the foot and leg structure.
The goal should be to cut our dog’s nails short enough that you can not hear them on your tile floor. In order to get the nails this short without hurting your dog (or making their nails bleed), your goal should be to get the “quick” (vein) to recede.
Since nail trimming can be an anxiety-laden experience for many dogs, start handling your puppy’s feet and trimming their nails when they’re young, so they become accustomed to the process. Some dogs will sit in your lap or on a table while you clip their nails, while others may need some form of restraint.
Tip: You can make the process more fun for your dog by letting them lick peanut butter off a spoon while you handle the nails.
will take time to recede them. It takes months, depending on starting length, to recede nails to our goal length. Be patient, and know that it is a marathon, not a sprint, to reach your goal. If you have a puppy, this is why nail maintenance is SO VERY IMPORTANT. You can avoid this hard work by properly maintaining
will need to follow up with a Dremel or file to get close enough to the quick
nail, as that is where the nerves are located, and is your dog’s normal everyday wear and tear. Using the s below as a guide. By doing a traditional cut line (the 45 degree one), the portion of the nail missed is the portion that must be taken off in order to get the dogs quicks to recede. The alternate cut line (the 90 degree cut) works to recede the quick, because you are doing BOTH cuts. The 45 to take length off, and the
90 to take the extra nail hood casing part off to make the quick believe it needs to recede to protect itself. The final product should be close to the quick, leaving the intact blood supply at the tip feeling unprotected, because you took the hood (its protection) off. In 2-3 days, you should have new growth around the quick, repeat the process.
When holding your pets paw firmly, but gently, place your thumb on the pad of a toe and your forefinger on the top of the toe on the skin above the nail. Make sure none of your dog’s fur is in the way. Push your thumb slightly up and backward on the pad, while pushing your forefinger forward. This extends the nail.
Grinders are also good for dogs with dark nails, where the quick is difficult to see. The use of a cordless Dremel rotary tool over a traditional nail clipper allows us to keep the nail as short as possible (even helping to work back the quick if their nails have become overgrown) without the risk of pain or bleeding. The other advantage is that the nail is left smooth and rounded; no more scratches from sharp, freshly-cut nails.
Many dogs show concern about the noise of a Dremel the first several uses. You can help desensitize your dog to the sound of the Dremel by: – turning on the tool and placing it near the food dish while your dog eats – turning on the tool and placing it near your dog while you play with their feet, toes and nails – turning on the tool and massaging your dog with the NON-ROTARY end (especially in more sensitive areas such as the neck, legs and underbelly)
To begin, keep nail trimming sessions short; you dont have to do all the nails the first try. It is best to end each session on a positive note, if you can successfully trim one or two nails and your dog still seems comfortable or even intrigued, stop, give a treat and come back to do a couple more nails later. To positively reinforce this style of nail trimming, be sure to give your dog treats only when they are NOT struggling and while the Dremel is still running.
Once your dog gets accustom to this type of nail trimming technique, you will find it can be a much more pleasant experience for both you and your dog!